[Jan 13, 2022] Fortinet NSE7_SDW-6.4 Real Exam Questions and Answers FREE
Pass Fortinet NSE7_SDW-6.4 Exam Info and Free Practice Test
NEW QUESTION 11
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
- B. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
- C. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- D. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
Answer: A,B
NEW QUESTION 12
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. Dead members require manual administrator access to bring them back alive
- B. SD-WAN interface becomes disabled and port1 becomes the WAN interface
- C. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
- D. Port2 might become alive when a single response is received from an SLA server
Answer: C
NEW QUESTION 13
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link health-check
- B. diagnose sys virtual-wan-link sla-log
- C. diagnose sys virtual-wan-link log
- D. diagnose sys virtual-wan-link intf-sla-log
Answer: B
Explanation:
Explanation/Reference: https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/943037/sla-logging
NEW QUESTION 14
What is the lnkmtd process responsible for?
- A. Monitoring links for any bandwidth saturation
- B. Processing performance SLA probes
- C. Logging interface quality information
- D. Flushing route tags addresses
Answer: A
NEW QUESTION 15
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- D. The 10 Mbps bandwidth is shared equally among the IP addresses.
Answer: A
NEW QUESTION 16
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two.)
- A. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices.
- B. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager.
- C. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager.
- D. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
Answer: A,B
Explanation:
Explanation/Reference:
NEW QUESTION 17
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. FortiGate created a single IPsec virtual interface that is shared by all clients
- B. There are separate virtual interfaces for each dial-up client
- C. 100.64.3.1 is one of the remote IP address that comes through index interlace 1.
- D. VPN static routes are prevented from populating the FortiGate routing table
Answer: B
NEW QUESTION 18
What are two roles that SD-WAN orchestrator plays when it works with FortiManager? (Choose two )
- A. It configures and monitors SD-WAN networks on FortiGate devices that are managed by FortiManager.
- B. It acts as an application that is released and signed by Fortinet to run as a part of management extensions on FortiManager
- C. It acts as a standalone device to assist FortiManager to manage SD-WAN interfaces on the managed FortiGate devices
- D. It acts as a hub FortiGate with an SD-WAN interface enabled and managed along with other FortiGate devices by FortiManager
Answer: A,D
NEW QUESTION 19
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- B. It acts as a policy compliance entity to review all managed FortiGate devices.
- C. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- D. It improves SD-WAN performance on the managed FortiGate devices.
- E. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
Answer: B,D
NEW QUESTION 20
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- B. It tags each route and references the tag in the routing table.
- C. It ensures route tags match the SD-WAN rule based on the rule order
- D. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
Answer: C
NEW QUESTION 21
Which three parameters are available to configure SD-WAN rules? (Choose three.)
- A. Application signatures
- B. Type of physical link connection
- C. URL categories
- D. Source and destination IP address
- E. Internet service database (ISDB) address object
Answer: B,D,E
NEW QUESTION 22
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )
- A. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links.
- B. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.
- C. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance.
- D. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub.
Answer: B,D
NEW QUESTION 23
Which three parameters are available to configure SD-WAN rules? (Choose three.)
- A. Type of physical link connection
- B. URL categories
- C. Application signatures
- D. Source and destination IP address
- E. Internet service database (ISDB) address object
Answer: B,D,E
NEW QUESTION 24
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It sends probe signals as health checks to the beacon servers on behalf of FortiGate
- B. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices
- C. It acts as a policy compliance entity to review all managed FortiGate devices
- D. It improves SD-WAN performance on the managed FortiGate devices.
- E. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server
Answer: B,E
NEW QUESTION 25
Which components make up the secure SD-WAN solution?
- A. FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy
- B. Telephone, ISDN, and telecom network.
- C. Application, antivirus, and URL, and SSL inspection
- D. Datacenter, branch offices, and public cloud
Answer: A
NEW QUESTION 26
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?
- A. The web filter profile must be enabled on the firewall policy
- B. The shaper mode must be applied per-IP shaper on the traffic shaping policy
- C. The URL category must be specified on the traffic shaping policy
- D. The application control profile must be enabled on the firewall policy.
Answer: A
NEW QUESTION 27
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- D. The 10 Mbps bandwidth is shared equally among the IP addresses.
Answer: A
Explanation:
Reference:
https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/885253/per-ip-traffic-shaper
NEW QUESTION 28
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. A peer ID is included in the first packet from the initiator, along with suggested security policies.
- B. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- C. XAuth is enabled as an additional level of authentication, which requires a username and password.
- D. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.
Answer: B,C
NEW QUESTION 29
......
Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
Latest NSE7_SDW-6.4 Exam Dumps Fortinet Exam: https://www.validtorrent.com/NSE7_SDW-6.4-valid-exam-torrent.html
New 2022 Latest Questions NSE7_SDW-6.4 Dumps - Use Updated Fortinet Exam: https://drive.google.com/open?id=1mbOwXTGnJwWXVLipEnsG0urQei4Xy8pA