[Dec 25, 2021] NSE7_SDW-6.4 Exam Dumps - Try Best NSE7_SDW-6.4 Exam Questions - ValidTorrent
Verified NSE7_SDW-6.4 exam dumps Q&As with Correct 37 Questions and Answers
NEW QUESTION 17
Refer to the exhibit.
Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology
Which two statements are correct if a user in Toronto sends traffic to London? (Choose two )
- A. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
- B. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN
- C. London generates an IKE information message that contains the Toronto public IP address
- D. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
Answer: B,D
NEW QUESTION 18
Which statement is correct about the SD-WAN and ADVPN?
- A. Spoke support dynamic VPN as a static interface.
- B. ADVPN interface can be a member of SD-WAN interface.
- C. Dynamic VPN is not supported as an SD-Wan interface.
- D. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.
Answer: C
NEW QUESTION 19
What is the lnkmtd process responsible for?
- A. Flushing route tags addresses
- B. Logging interface quality information
- C. Monitoring links for any bandwidth saturation
- D. Processing performance SLA probes
Answer: C
NEW QUESTION 20
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?
- A. Dead members require manual administrator access to bring them back alive
- B. SD-WAN interface becomes disabled and port1 becomes the WAN interface
- C. Port2 might become alive when a single response is received from an SLA server
- D. Subnets 100 .64-1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
Answer: B
NEW QUESTION 21
Refer to exhibits.
Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.
Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)
- A. All the existing sessions will be blocked from using port1 and port2.
- B. All the existing sessions that do not use SNAT will be flushed and routed through port1.
- C. All the existing sessions using SNAT will be flushed and routed through port1.
- D. All the existing sessions will continue to use port2, and new sessions will use port1.
Answer: C,D
NEW QUESTION 22
Which statement about using BGP routes in SD-WAN is true?
- A. Dynamic routing protocols can be used only with non-encrypted traffic
- B. Adding static routes must be enabled on all ADVPN interfaces.
- C. VPN topologies must be form using only BGP dynamic routing with SD-WAN
- D. Learned routes can be used as dynamic destinations in SD-WAN rules
Answer: C
NEW QUESTION 23
What is the lnkmtd process responsible for?
- A. Monitoring links for any bandwidth saturation
- B. Flushing route tags addresses
- C. Logging interface quality information
- D. Processing performance SLA probes
Answer: C
NEW QUESTION 24
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link sla-log
- B. diagnose sys virtual-wan-link log
- C. diagnose sys virtual-wan-link intf-sla-log
- D. diagnose sys virtual-wan-link health-check
Answer: A
NEW QUESTION 25
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. There are separate virtual interfaces for each dial-up client
- B. VPN static routes are prevented from populating the FortiGate routing table
- C. FortiGate created a single IPsec virtual interface that is shared by all clients
- D. 100.64.3.1 is one of the remote IP address that comes through index interlace 1.
Answer: A
NEW QUESTION 26
Which three parameters are available to configure SD-WAN rules? (Choose three.)
- A. Source and destination IP address
- B. Type of physical link connection
- C. Application signatures
- D. Internet service database (ISDB) address object
- E. URL categories
Answer: A,D,E
NEW QUESTION 27
Refer to exhibits.
Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?
- A. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
- B. The guaranteed-10mbps option must be selected as the reverse shaper option.
- C. The guaranteed-10mbps option must be selected as the per-IP shaper option
- D. The reverse shaper option must be enabled and a traffic shaper must be selected
Answer: B
NEW QUESTION 28
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It ensures route tags match the SD-WAN rule based on the rule order
- D. It tags each route and references the tag in the routing table.
Answer: C
NEW QUESTION 29
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?
- A. The web filter profile must be enabled on the firewall policy
- B. The application control profile must be enabled on the firewall policy.
- C. The URL category must be specified on the traffic shaping policy
- D. The shaper mode must be applied per-IP shaper on the traffic shaping policy
Answer: A
NEW QUESTION 30
Which three parameters are available to configure SD-WAN rules? (Choose three.)
- A. Source and destination IP address
- B. Type of physical link connection
- C. URL categories
- D. Application signatures
- E. Internet service database (ISDB) address object
Answer: A,B,E
NEW QUESTION 31
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. ADVPN should only be enabled on unmanaged FortiGate devices.
- B. The protected subnets should be set to address object to all (0.0 .0. o/o).
- C. Each VPN device has a unique pre-shared key configured separately on phase one
- D. On the hub VPN, only the device needs additional phase one sett
Answer: C
NEW QUESTION 32
Refer to the exhibit.
Which statement about the command route-tag in the SD-WAN rule is true?
- A. It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.
- B. It enables the SD-WAN rule to load balance and assign traffic with a route tag
- C. It ensures route tags match the SD-WAN rule based on the rule order
- D. It tags each route and references the tag in the routing table.
Answer: C
NEW QUESTION 33
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- B. The use of Diffie Hellman keys is limited by the responderand needs initiator acceptance
- C. XAuth is enabled as an additional level of authentication which requires a username and password
- D. A peer ID is included in the first packet from the initiator, along with suggested security policies
Answer: C
NEW QUESTION 34
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?
- A. The dead member interface stays unavailable until an administrator manually brings the interface back.
- B. Check interval is the time to wait before a packet sent by a member interface considered as lost.
- C. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
- D. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
Answer: D
NEW QUESTION 35
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. The protected subnets should be set to address object to all (0.0.0.0/0).
- B. On the hub VPN, only the device needs additional phase one settings.
- C. ADVPN should only be enabled on unmanaged FortiGate devices.
- D. Each VPN device has a unique pre-shared key configured separately on phase one.
Answer: D
Explanation:
Explanation/Reference:
NEW QUESTION 36
Refer to the exhibit.
Which statement about the trace evaluation by FomGate is true?
- A. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
- B. Packets exceeding the configured concurrent connection limit are dropped based on tfte priority configuration.
- C. The packet exceeded the configured bandwidth and was dropped based on the priority configuration
- D. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
Answer: B
NEW QUESTION 37
Refer to the exhibit.
Which two statements about the debug output are correct? (Choose two )
- A. The debug output shows per-lP shaper values and real-time readings.
- B. Traffic being controlled by the traffic shaper is under 1 Kbps
- C. FortiGate provides statistics and readings based on historical traffic logs.
- D. This traffic shaper drops traffic that exceeds the set limits.
Answer: A,C
NEW QUESTION 38
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )
- A. It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links
- B. It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub
- C. It provides direct connectivity between all sites by creating on-demand tunnels between spokes.
- D. It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance
Answer: A,B
NEW QUESTION 39
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
- A. Both SD-WAN member interfaces have used separate SLA targets.
- B. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- C. Port1 became dead 1ecause no traffic was offload through the egress of port1.
- D. SD-WAN member interfaces are affected by the SLA state of the inactive interface
Answer: B
NEW QUESTION 40
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. VPN static routes are prevented from populating the FortiGate routing table.
- B. There are separate virtual interfaces for each dial-up client.
- C. FortiGate created a single IPsec virtual interface that is shared by all clients.
- D. 100.64.3.1 is one of the remote IP address that comes through index interface 1.
Answer: C,D
NEW QUESTION 41
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. A peer ID is included in the first packet from the initiator, along with suggested security policies.
- B. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.
- C. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- D. XAuth is enabled as an additional level of authentication, which requires a username and password.
Answer: C,D
NEW QUESTION 42
......
Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
| Topic 6 |
|
Fortinet NSE7_SDW-6.4 Test Engine PDF - All Free Dumps: https://www.validtorrent.com/NSE7_SDW-6.4-valid-exam-torrent.html
Get New NSE7_SDW-6.4 Certification – Valid Exam Dumps Questions: https://drive.google.com/open?id=1mbOwXTGnJwWXVLipEnsG0urQei4Xy8pA