100% Pass Your 301a Exam Dumps at First Attempt with ValidTorrent [Q58-Q76]

Share

100% Pass Your 301a Exam Dumps at First Attempt with ValidTorrent

Penetration testers simulate 301a exam PDF

NEW QUESTION 58
What should an LTM Specialist configure on an LTM device to send AVR notification emails?

  • A. Syslog on the LTM device to send to an SMTP server
  • B. Email notification to be sent via SMTP from the LTM device
  • C. Email notification to be sent via iControl from the LTM device
  • D. Custom SNMP traps on the LTM device for AVR notifications

Answer: B

 

NEW QUESTION 59
A LTM device needs to load balance active and passive FTP traffic while using only a single virtual server.
Which virtual server type should an LTM Specialist configure on the LTM device?

  • A. Standard
  • B. Forwarding (Layer 2)
  • C. Forwarding (IP)
  • D. Stateless
  • E. DHCP relay

Answer: C

 

NEW QUESTION 60
An LTM Specialist needs to load balance an application using an LTM device to meet the requirements:
The application servers do NOT Support SSL, but client access to the application should be secured.
Multiple requests from the same client should be sent to the same pool member.
All pool members will have roughly the same processing power, and traffic should be distributed evenly.
The LTM device is NOT the pool members' default gateway.
which configuration should the LTM Specialist.

  • A. a performance L4 virtual server with a Client SSL profile and Source Address persistence
  • B. A standard virtual server with a SNAT, HTTP profile, Client profile, andd cookie persistance.
  • C. a performance 14 virtual server with a SNAT and cookie persistence
  • D. A performance L4 virtual server with a SNAT, HTTP profile. Server SSL profile, and cookie persistence
  • E. A standard virtual server with a SNAT, HTTP profile Server SSL profile, and cookie persistence

Answer: B

 

NEW QUESTION 61
AN LIM Specialist must upgrade the VCMP Guest active/standby LTM pair from version 11.3 to 11.5.3 on two VCMP Hosts.
where should the LTM Specialist import the latest 11.5.3 ISO images?

  • A. to the primary VCMP Host and the active Guest instance
  • B. to the VCMP Guest instances
  • C. to both VCMP Hosts
  • D. to the secondary vCMP Host and the standby Guest instance

Answer: B

 

NEW QUESTION 62
An LTM Specialist needs to enable TCP connection re-use for a non-HTTP application. The application uses a simple request response protocol where each request and response is contained within a single packet.
Which configuration option should the LTM Specialist adjust?

  • A. assign a OneConnect profile
  • B. increase the connection limit for pool members
  • C. increase the idle Timeout in a custom TCP profile
  • D. use a Performance (Layer 4) Virtual Server

Answer: A

 

NEW QUESTION 63
A virtual server is configured to handle https traffic. The clientssl profile is configured to use a2048-bit RSA key. Due to security requirements, is the LTM Specialist needs to use a 4096-bit RSA key in the future.
What two effects will this change have on the BIG-IP device? (Choose two)

  • A. Increase of TLS Renegotiation
  • B. Increase of CPU usage on the BIG-IP device
  • C. Decrease to 90% of licensed TPS
  • D. Decrease to 20% of licensed TPS
  • E. Increased of concurrent connection on client-side

Answer: B,D

 

NEW QUESTION 64
An LTM Specialist reports that an application si no longer reachable after it has been upgraded.
Nothing has been changed in the configuration on the LTM device.
The logs indicates that health monitors to all servers have failed as shown:
What should the LTM Specialist verify next?

  • A. That the TCP hand shake with the servers is stall completed using tcpdump
  • B. That the firewall between the BIG-ip device and servers is still allowing HTTP
  • C. That the can still ping the servers from te BIG_ IP device.
  • D. That the custom receive string for the HTTP monitor has changed with the upgrade

Answer: D

Explanation:
The log shows that tcp detection is normal, but http detection is abnormal. So we should pay attention to the detection problem of http level

 

NEW QUESTION 65
Consider the monitor configuration displayed below.

What is the status of a pool member that responds with ''200 OK''?

  • A. disabled
  • B. available
  • C. down
  • D. unknown

Answer: C

 

NEW QUESTION 66
The network team introduces a new subnet 10.10.22.0/24 to the network. The route needs to be configured on the F5 device to access this network via the 30.30.30.158 gateway.
How should the LTM Specialist configure this route?

  • A. Tmsh modify net route 10.10.22/24 gw 30.30.30.158
  • B. Tmsh add net route 10.10.22/24 gw 30.30.30.158
  • C. Tmsh changey net route 10.10.22/24 gw 30.30.30.158
  • D. Tmsh create net route 10.10.22/24 gw 30.30.30.158

Answer: D

 

NEW QUESTION 67
An LTM Specialist needs to use a set of addresses to access an Internet website in an outbound configuration.
Which feature should the LTM Specialist configure?

  • A. NAT address
  • B. SNAT pool
  • C. SNAT address
  • D. NAT pool

Answer: B

 

NEW QUESTION 68
An LTM device an application that requires all connections to be secured via SSL The device must verify that request contain a specific cookie before allowing the request to be sent to the pool member.
Which virtual server type should an LTM Specialist configure on the LTM device?

  • A. Forwarding (IP)
  • B. Performance (Layer 4)
  • C. Performance (HTTP)
  • D. Standard
  • E. Stateless

Answer: D

 

NEW QUESTION 69
Refer to the exhibit.

The http monitor is applied to a pool. All members are enabled. One server responds as follows.

What is the resulting status of this poo! member?

  • A. Offline (Enabled)
  • B. Offline (Disabled)
  • C. Available (Enabled)
  • D. Unavailable (Disabled)

Answer: A

Explanation:
The first picture "Send String" and "Receive String" are not clear. Send String should be "GOOD", the response packet does not contain this keyword. Receive Disable String is completely unclear. If the response packet contains the content of Receive Disable String at this time, it will be Available (Disabled), If the content of Receive Disable String is not included, then Offline (Enabled).

 

NEW QUESTION 70
Traffic to a pool of SFTP servers that share storage must be balanced by an LTM device.
What are the required profile and persistence settings for a standard virtual server?

  • A. tcp, ftp - Source address persistence
  • B. tcp, ctientsst, ftp serverssl persistence
  • C. tcp - no persistence profile will be used
  • D. tcp, clientssl, serverssl persistence

Answer: A

 

NEW QUESTION 71
The network team has recently added a new syslog server with IP address 10.1.1.1.
Which command adds the new syslog entry on the F5 LTM device?
A)

B)

C)

D)

  • A. Option D
  • B. Option C
  • C. Option A
  • D. Option B

Answer: B

 

NEW QUESTION 72
TWO BIG-IP appliances need to be configured to load balance multiple firewall in a firewall sandwich, Which health monitor setting should be used to verify that the firewalls are able to forward traffic?

  • A. Adaptive
  • B. Reverse
  • C. Up internal
  • D. Transparent

Answer: D

Explanation:
Sandwich architect firewalls are generally deployed transparently. You can enable Transparent to point to the next-hop address of the firewall and associate it with the firewall pool member for detection.

 

NEW QUESTION 73
One LTM device in an HA pair of LTM devices is unable to reach its default gateway. An HA Failover event needs to happen.
Which configuration item enables this behavior?

  • A. Gateway pool monitor
  • B. iRule
  • C. Gateway pool
  • D. Gateway Fail Safe

Answer: D

 

NEW QUESTION 74
An LTM Specialist needs to add a pool that will load balance MYSOL services. It has four members, each with differing hardware platforms. All pool members are already assigned to another pool for load balancing FTP traffic.
Which load balancing method is most effective when the LTM Specialist sets up the pool?

  • A. Round Robin
  • B. Observed (node)
  • C. Predictive member)
  • D. Least Connections (node)

Answer: B

 

NEW QUESTION 75
Refer to the exhibit.

The pool shown is configured with four pool members in a variety of states. The application is receiving a large number of request. The LTM Specialist needs to make changes to make sure that all members receive the same levels of traffic.
Which changes need to be made?

  • A. Enable 10.80.1.40 disable priority group activation, enable ratio
  • B. Enable 10.80.1.40 and 10.80.1.1.20 disable group activation, enable Round Robin
  • C. Enable 10.80.1.40 and 10.80.1.20 disable priority group activation, enable ratio.
  • D. Enable 10.80.1.20 disable priority group activation, enable Round Robin

Answer: B

 

NEW QUESTION 76
......

All 301a Dumps and Training Courses: https://www.validtorrent.com/301a-valid-exam-torrent.html

Help candidates to study and pass the BIG-IP LTM Specialist: Architect Set-Up & Deploy Exams hassle-free: https://drive.google.com/open?id=1MNWzt5OSzwRRRN_HhQysxK7YAFfs4ayY